top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

How will UE use MCC MNC values (p-access-network-info header) in LTE-IMS integration?

+1 vote
795 views

When a UE is doing IMS registration, it will bring p-access-network-info header in the register message. There's MCC MNC value within this header, my question is :

How will UE use MCC MNC values? depends on the MCC MNC broadcast from eNB or using IMSI in the UE?

Is there any document describing this?

posted Feb 22, 2016 by anonymous

Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button

1 Answer

0 votes

Header P-Access-Network-Info captures the access network as perceived by the UE and communicated to IMS.

For LTE it is either access-type= 3GPP-E-UTRAN-FDD or 3GPP-E-UTRAN-TDD and UMTS it is UTRAN-cell-id-3gpp parameter which assumes the value of CGI footprint where UE is located.

answer Feb 23, 2016 by Salil Agrawal
Similar Questions
+1 vote

How to config Nokia FL15 VoLTE/IMS when changing MCC-MNC?
If providing step by step, it's perfect, We want to simulate some operator PLMN domain?.

+6 votes

I was going through IMS call flow and came to know that an IP sec tunnel is established between UE and P-CSCF . I could not find out reasoning behind it.

+2 votes

What signalling messages are exchanged between LTE and IMS nodes for the IMS de-registration ?

+6 votes

Does LTE network send any specific message to UE so that UE come to know network supports IMS call ?
Or
Does the LTE network broadcast information such as "it does not support IMS call" ?

+2 votes

Is it mandatory to establish a separate default bearer to exchange IMS signaling messages between UE and IMS network nodes ? Can't internet default bearer be used for the same ?

...