top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

TAU procedure within S1 Based Handover

+2 votes
333 views

During s1 based HO(normal) without SGW change, Target MME sends Modify Bearer Request to Serving GW. At the same time TAU procedure is triggered without SGW change, again Target MME sends Modify Bearer Request to Serving GW. Is it mandatory to send Modify Bearer Request two times. If yes, what's the difference between the two messages. please provide me reference...

posted Jun 22, 2016 by Mohanraj R

Looking for an answer?  Promote on:
Facebook Share Button Twitter Share Button LinkedIn Share Button

Similar Questions
0 votes

Which of the following statements is FALSE regarding the S1-based handover?

A. The SGW may be relocated.
B. The MME may be relocated.
C. Direct data forwarding via the X2 interface may be used.
D. Indirect data forwarding via the SGW may be used.
E. None of the above statements are false.

+1 vote

In case of hub-and-spoke topology, X2 messaging can travel all the way back to an aggregation point, which may be co-located with EPC. In such scenario both X2 and S1 traverses same physical path (a.k.a X2 over S1). Please consider both Intra-MME and Inter-MME handover scenarios. Would X2 based handover in such a case yield advantage over S1 based handover. Thanks.

+5 votes

As part of S1-AP procedure with MME relocation, Handover Required message sent to source MME. Target eNodeBId is present within the handover required. How source MME figure out target cell is being served by XYZ MME and sends "Forward relocation Request" message to XYZ MME.

Please provide reference also if it is there ?

...