top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

LTE- how much percent of throughput affected due to measurement gap in lte

+1 vote
705 views

how much percent of throughput affected due to measurement gap in lte

posted Sep 30, 2016 by anonymous

Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button

1 Answer

0 votes

Hi,
It depends on the ENB scheduler. If ENB scheduler is QOS then there wont be any throughput degradation.

answer Oct 3, 2016 by Jaganathan
Similar Questions
+1 vote
Will UE be able to quit measurement GAP if the target load balance cell doesn't meet throughput condition?

As per my understanding No it won’t, It will still measure the Inter frequency until the enodeb sends the interfreqency relation.

So if If it won't quit measurement gap because target cell doesn't meet throughput condition, then the UE on the source cell speeds will degrade as it stuck on measurement gap.

Should node allow UE quit to measurement gap in this scenario?

0 votes
Measurement gap length in LTE?

In meas gap calculation
SFN mod T = FLOOR(gapOffset/10);
subframe = gapOffset mod 10; consider gap0 i.e 40ms (MGRP) .
T = MGRP/10 ;

Here if gapoffset is ----> 28 ,then subframe start is --> 28 % 10 = 8 . and SFN is 2 (SFN % T = FLOOR(28 / 10) ) ; T = 40 / 10 = 4;
so my doubt is as spec say meas gp length is 6ms , so meas gap for gapoffset 28 , whether it will exend to SFN 3 of subframes 0 , 1 , 2,3 (as in SFN 2 sub frames is 8 , 9 ) , or only it permits to SFN 2 with subframe 8,9 .

+3 votes
How harq feedback is considred by eNB in measurement-gap?

We as eNB dont receive harq-feedback in measurement-gap period. Threfore will UE send the harq-feedback in next subframe?

+2 votes
If Measurement Gap and paging cycle collide how UE will handle?

How Paging cycle and measurement Gap is calculated?

+2 votes
Can UE monitor RAR in measurement Gap?

If rach response occurs in measurement gap can UE monitor the PDCCH?

...