top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

What is the meaning of PUCCH/ SRS release request in LTE ?

+1 vote
844 views
What is the meaning of PUCCH/ SRS release request in LTE ?
posted Oct 9, 2013 by Neeraj Mishra

Looking for an answer?  Promote on:
Facebook Share Button Twitter Share Button LinkedIn Share Button

Similar Questions
0 votes
UE context release request and signal loss

Hi,

this is the scenario:

  1. UE is attached to an eNodeB
  2. UE performs (or not performs, it's the same) UL/DL data traffic
  3. After a few seconds: on UE I see on display that icon signal it is emptying. There is no signal anymore. UE doesn't send any particular message.
  4. Network side, I see that eNodeB sends to MME a "UE context release request" with cause "radio connection with UE lost" or "user inactivity" (also when UE is downloading/uploading!!!).
  5. As result, UE is no more able to attaches to eNodeB again: it is necessary the airplane mode to initiate the attach procedure again.

I think that UE loses the signal after eNodeB sends the "UE context release request"...

Whose fault is it?
Is device faulty? Because the problem is not present for other devices...
Or is eNodeB faulty? Because the problem is not present under another eNodeB.

I don't understand. Sorry and thank you if you'll answer.

+5 votes
Why UE sends RRC Connection Request followed by EUTRA triggered RRC Connection Release?

I have scenario where in I have to gracefully shutdown/disconnect all UE's in connected state at RRC and go for reboot of the complete system. Here are the steps that I have followed -
1. Find all UE's in RRC which are in connected state
2. Send UE Context Release Request to MME for the UE with Cause as Misc_Cause_O_M_Intervention.
3. Once we receive UE Context Release Command from MME, Start UE Release procedure at eNodeb.
4. When we send RRC Connection Release Use Cause as "other"
5. Send UE Context Release Complete to MME.
6. Repeat Above steps for all UE's.
7. Go for reboot.

Here in this scenario, after sending RRC Connection Release to UE, it is immediately trying to connect to eNodeb with message RRC Connection Request with establishmentCause as "HighPriorityAccess" and MME is releasing the UE again.

I wanted to know why UE is trying to connect again.

FYI: UE was just in connected state and it was doing any data transfer (Both in Uplink and Downlink).

...