top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

How does eNodeB configure an UE for the proximity indication procedure ?

+3 votes
348 views

I went through RRC specification for proximity indication procedure. I could not figure out what configuration eNodeB does to get proximity indication message from an UE ?

posted Jul 9, 2015 by Harshita

Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button

1 Answer

0 votes

Proximity indication procedure is initiated by source eNodeB. The objective of initiating this procedure is to handover UE from source eNodeB to target Home eNodeB (CSG cell).

Enodeb sends RRC connection reconfiguration message to UE by enabling ReportProximityConfig for E-UTRA frequency.
UE starts searching for E-UTRA CSG cells and sends proximity (entering/leaving CGS coverage) indication message. Based on the proximity indication message receives from UE, source eNodeB triggers further measurement configuration message and ask UE for measurement reports.
UE sends measurement report to eNodeB and eNodeB takes further actions on handover.

answer Jul 12, 2015 by Vimal Kumar Mishra
Similar Questions
+3 votes

Need clarity on following items:
1. What is the use of "UE selected plmn" information for an eNodeB ?
2. Is the ECGI/TAI constructed based on the primary plmn (PLMN broadcasted in 0th index in SIB1 ) or based on the UE selected PLMN ?

...