top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

Understanding A3 AND A4 LTE event UE measurement report?

+3 votes
816 views

I understood A3 and A4 in the following way -

A3 event - UE measures both serving and neighbour cell?
A4 event - UE measures only neighboring cell?

Please correct me if my understanding is wrong.

posted Jul 12, 2015 by anonymous

Looking for an answer?  Promote on:
Facebook Share Button Twitter Share Button LinkedIn Share Button
A3: Yes, Ue mesure both Serving neighbor cell but with the following condition:
The LTE Event A3 is triggered when a neighbouring cell becomes better than the serving cell by an offset. The offset can be either positive or negative. The event is triggered when the following condition is true:

MEASneigh + Oneigh,freq + Oneigh,cell - Hyst > MEASserv + Oserv,freq + Oserv,cell + Offset

A4: yes, Ue measures only neighboring cell but with the below condition.
When  a neighbouring cell becomes better than a threshold.

MEASneigh + Oneigh,freq + Oneigh,cell - Hyst > Threshold

Similar Questions
+1 vote

Does UE reports neighbor cells in order of RSRP in measurement report of A3 event ?

+4 votes

A3 :- Neighbour becomes offset better than PCell
A6 :- Neighbour becomes offset better than SCell

Please Clarify the difference

+4 votes

What is difference between event A3 and A4 in lte from handover purpose.
what is role of A3 in handover

+2 votes

I was going through the measurement configuration sends from eNodeB to UE in RRC Connection Reconfiguration message.
I saw that multiple events have been defined and are used. Couple of parameters are considered to detect entering and leaving condition of an event for example event A1. Now I have a question "Threshold and Hys values are same for all the cell or it may different". Does the standard define the value of all these parameters or network operator defines ? If network operator does then what are points to derive these values ?

...