Unlike for A3 and A5 events, for A6 event frequency offset is not considered while evaluating entering and leaving condition. Can anyone please explain this particular case ?
I was going through the measurement configuration sends from eNodeB to UE in RRC Connection Reconfiguration message. I saw that multiple events have been defined and are used. Couple of parameters are considered to detect entering and leaving condition of an event for example event A1. Now I have a question "Threshold and Hys values are same for all the cell or it may different". Does the standard define the value of all these parameters or network operator defines ? If network operator does then what are points to derive these values ?
Since both the events B1 and B2 are used for Inter RAT measurement reporting. Which one is chosen by eNodeB and on what basis ? Is there any dependency on UE capability for that ?
A3 :- Neighbour becomes offset better than PCell A6 :- Neighbour becomes offset better than SCell
Please Clarify the difference
While going through measurement events we will find two tern offset and Hysteresis , offset is quite clear as it is kind of ∇X in terms of strength of signal but can any one elaborate points on Hysteresis ?
