top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

While Handover why RLF is occurring?

0 votes
451 views

While Handover why RLF is occurring?While making handover UE sending RLF in target ENB what might be the reason?

posted Sep 5, 2017 by Ankit Mishra

Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button

2 Answers

+2 votes

After rrc-reconfig complete UE goes for RACH procedure with the target cell, it must have failed while performing rach procedure on target cell. Can be a ping-pong issue.

answer Sep 6, 2017 by Rohit Karadkar
+1 vote

Whenever handover procedure gets failed, UE triggers re-establishment towards target cell or source cell based on the signal strength. To make handover procedure successful, few parameters such as hysteresis, RSRP etc are configured with correct value so that handover decision is taken at source eNodeB at the right time and it avoids handover failure.
If RRC re-establishment occurs as handover failure at the source eNodeB then it is considered as too early handover. It means target cell radio strength was not good enough to make handover successful for the UE. In other case when re-establishment comes to target cell it means handover was triggered late from source cell.

answer Sep 6, 2017 by Harshita
Similar Questions
+2 votes

How ever same ENB is handling source and target cell, then why do we need handover just RACH is enough to make synch ?

+4 votes

What is the use of TAI , which is included in handover required message ?

...