top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

Android: Suppressing scan results from wifi scanning

+2 votes
254 views

Is there a way to only show the remember networks in wifi scanned results from settings/wifi?

posted Nov 4, 2013 by Sheetal Chauhan

Looking for an answer?  Promote on:
Facebook Share Button Twitter Share Button LinkedIn Share Button

Similar Questions
0 votes
How to convert Android phone to WiFi repeater?

I want to convert my android phone to a wifi repeater programatically and without rooting the phone. Can anyone help me with this?

Any help would be great (not looking for manual change of phone to HotSpot, or adding network but to do it programatically)

+3 votes
Connecting to an Android device via WiFi

I have Ubuntu 12.04 and I can connect to my Android device via USB. I installed MTP support and it works fine, as it seems.

Also, my Ubuntu computer and the Android device is connected to the Internet via WiFi. Is there an easy way to connect them to each other via WiFi for easy file sharing? A step by step instruction would be nice, as I am not even sure where to start.

+1 vote
Reconnecting to the wifi automatically for Android device?

The Settings application takes care of showing up an interface which helps to connect to a WIFI. Switching off the router will disconnect the phone from WIFI.
Now, on switching the router back on, who takes care of reconnecting to this WIFI automatically? Is it the Settings application or is it done at the framework level?

+2 votes
Wifi Direct Peers IP for Android

I wanted to know if there is a way that make the group owner (group owner is the device who called this method wManager.createGroup() ) know the peers IPs to be able to send data to them over these IPs? and if there is no implemented way in WiFi-direct API to do this issue, can you tell me how I can solve this problem?

0 votes
Are there some ways to keep both ethernet and wifi connection on a android phone?

There are two connection, ethernet and WiFi. Ethernet has higher priority than wifi, so connectivity service tears down the lower priority connection. The result is in wifi setting UI, the wifi shows "on", but no APs can be shown and mirracast also can not be used, as both wifi and p2p interface are disabled.

Are there some ways to keep both ethernet and wifi connection?

...