top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

LTE, GTP: What is the use of create bearer request procedure and how does it work ?

+3 votes
1,558 views

I am looking for actual use of this procedure ?

posted Jan 6, 2014 by Harshita

Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button

1 Answer

+1 vote

Create bearer request message is sent by PGW to SGW and SGW to MME as part of either UE requested bearer resource allocation procedure or UE requested bearer resource modification procedure. I am covering here only LTE nodes. This message can also sent by PGW to SGW as part of network initiated dedicated bearer establishment procedure. A dedicated bearer might be GBR or non-GBR based on QoS requirement. One more thing, every dedicated bearer is linked to a default bearer.

answer Jan 6, 2014 by Vimal Kumar Mishra
Similar Questions
+1 vote

GTP tunnel id is a 32-bit long value over one IP address combination. Suppose there are two nodes A and B which has IP addresses X and Y respectively. Is it possible when first GTP tunnel id range gets exhausted then both the nodes starts using different IP address combination and again GTP tunnel id range can be re-used ? If it is impossible then what could be the reason ?

0 votes

In LTE , after successful completion of attach-process , i want to fail the dedicated radio bearer , which is initiated by PGW ,what is the procedure to fail the dedicated radio bearer

...