LTE: What enodeb does after receiving proximity indication from UE ?

615 views

LTE: What enodeb does after receiving proximity indication from UE ?

posted Jan 15, 2014 by Neeraj Mishra

Share this question

Facebook Share Button

Twitter Share Button

LinkedIn Share Button

1 Answer

Objective behind proximity indication, handover from macroEnodeB to HeNB. Once eNodeB sends proximity related configuration to UE via rrc connection reconfiguration. UE applies this information at its own end and start searching CSG cell(s) which are in the UE's CSG whitelist. When ue detects a particular CSG cell, It sends proximity indication to eNodeB that it has detected an E-UTRA frequency, in which CSG cell is working. Then eNodeB may ask the UE to sends measurement report and UE sends necessary information to eNodeB in measurement report.
Upon receiving measurement report, eNodeB initiate basic handover procedure.
Please correct me if I am wrong.

answer Jan 15, 2014 by Vimal Kumar Mishra

Similar Questions

+1 vote

LTE: What MME does after receiving UE capabilities information from the eNodeB for an UE ?

What is the significance of UE capability Information at MME ? What decisions are affected based on the UE capability information ?

+3 votes

How does eNodeB configure an UE for the proximity indication procedure ?

I went through RRC specification for proximity indication procedure. I could not figure out what configuration eNodeB does to get proximity indication message from an UE ?

0 votes

What does UE do after receiving Paging message ?

If there is data/call for the UE, SGW sends DL Data Notification to MME, MME sends S1AP Paging message to all the eNodeBs for the given TAI list and finally ENodeB broadcast Paging at DRX interval.

Now UE receives the Paging message and moves from RRC/ECM-Idle state to RRC/ECM-Connected state.

Does UE recalculates PCI again, then reads MIB and SIB1,2 before sending RACH Preamble ?

+1 vote

What will be the behaviour of EnodeB with MME after receiving RRC Connection Reestablishment Complete message???

Which message EnodeB will communicate to MME after Receiving the Reestablishment Complete message from UE. what else messages will transverse between EnodeB and MME, before sending Reconfiguration message to UE from EnodeB after Reestablishment complete message has been received at EnodeB.

+1 vote

LTE: What eNodeB does after receiving S1 setup response ?

In S1-Setup Request message, eNodeB tells max # (6) of broad casted PLMNs. In S1-Setup response message, MME responds back to eNodeB with maxnoofPLMNsPerMME(32) IE. I am not able to find the reason that why maxnoofPLMNsPerMME is 32 even eNodeB can broadcast maxium of 6 ?

...